Damp Gone is supplied as a concentrate and must NOT be diluted with water.
Damp Gone Organic brings you an eco-friendly solution to damp-proofing, using organic technology to prevent moisture penetration on porous surfaces. Perfect for green-conscious homeowners, it safeguards cement, concrete, and plastered walls against damp, mold, and algae without harsh chemicals. Available in 1L, 5L, and 25L options, Damp Gone Organic is ideal for both small touch-ups and large-scale projects. Enjoy peace of mind knowing you’re choosing a natural, sustainable approach to moisture control, backed by a 5-year guarantee for lasting results.
R300.00 – R4,500.00
Damp Gone is supplied as a concentrate and must NOT be diluted with water.
Imparting water repellence to:
Damp Gone is used for impregnating the surfaces of masonry materials when suitable means achieving an adequate uniform coating. Damp Gone is recommended for treating the outside walls, inside walls of buildings and concrete slabs. The application may give rise of white spots.
Damp Gone should be stored in iron drums or plastic containers. Tin -plate aluminum, galvanized, glass or lacquered containers are not suitable. IN the sealed container Damp Gone has a shelf life of at least 12 months. Storage temperatures should not drop below -80 C. If crystal form due to low storage temperatures, these will redissolve when the product is allowed to warm up. The product must then be stored at a temperature above 0C.
Damp Gone is strongly alkaline and corrosive as a concentrate form. Goggles should always be worn when handling the product. Any splashes on the skin should be washed of with plenty of water. If any product gets into eyes, wash them immediately with plenty of water and seek medical advice because of the effect of corrosive alkaline. Clothing wetted with damp gone must be taken off immediately.
This product can be applied with pump sprayer or painted on with brush.
Appearance: Clear to hazy, colorless
Active agent: Silane/Siloxane
Solvent: Concentrate
Flash point: Non-Flammable
Damp Gone Organic brings you an eco-friendly solution to damp-proofing, using organic technology to prevent moisture penetration on porous surfaces. Perfect for green-conscious homeowners, it safeguards cement, concrete, and plastered walls against damp, mold, and algae without harsh chemicals. Available in 1L, 5L, and 25L options, Damp Gone Organic is ideal for both small touch-ups and large-scale projects. Enjoy peace of mind knowing you’re choosing a natural, sustainable approach to moisture control, backed by a 5-year guarantee for lasting results.
| Size | 1L, 5L, 25L |
|---|
Application Guide
For Raw Plaster, Concrete Slabs, Natural Stone Cladding, and Tiles
Measure Moisture Levels
Use a moisture meter to check plastered walls or concrete slabs. Ensure the moisture reading is 20% or lower for optimal results with Damp Gone. Higher readings dilute the product, reducing effectiveness.
Drying Time for Natural Stone and Tiles
Natural stone cladding or tiles should be exposed to sunlight for at least four days after rain or washing to allow full drying before applying Damp Gone.
Drying Time for Internal Walls
Internal walls require more time to dry compared to external walls. Use a moisture meter and wait until the reading is 20% or less before application.
Application Tools
Apply Damp Gone with a brush or pump spray bottle (a pump spray bottle is preferred).
Important Application Instructions: Wet-on-Wet Process
Damp Gone must be applied as a wet-on-wet application:
Tip: Avoid covering large areas at once, as the first coat may dry before the second coat is applied. Drying times vary depending on the material’s porosity and whether the application is indoors or outdoors. Test a small section first to monitor drying time.
For Painted Walls
Surface Preparation
Remove any loose paint and complete all prep work before applying Damp Gone.
Application
Spray two wet-on-wet coats of Damp Gone on the entire wall or affected area.
Drying Time Before Painting
Allow the wall to dry for two days after Damp Gone application. Then, you can apply plaster primer and paint.
Note: If white spots appear after painting, it’s just Damp Gone continuing to dry the walls—nothing to worry about.
Coverage (Wet-on-Wet, Two Coats on Plastered Walls)
Coverage may vary based on material porosity. Below are approximate coverage rates:
For questions or assistance, please contact: Renato van Tonder
📞 079 111 9902
🌐 www.dampgone.co.za
Reviews
There are no reviews yet.